we design, we manufacture, we're stylish, worldwide : gear to goannawhere

:Recovery Straps


The 4WD Systems Recovery/Snatch Straps have been specially designed for the safe, fast recovery of bogged vehicles.

 

Advertised Specials


Choose one of our products:

 

  Choose one of the following:

Snatch Strap,
Winch Extension Strap,
Tree Trunk Protector

 

Snatch Straps

Snatch Straps are one of the most important pieces of recovery gear you can carry. They allow one vehicle to retrieve or 'snatch' another out of trapped situations, eg. in mud and sand.

Constructed of H.E. Nylon 8 ton breaking strain
50 mm wide Resistant to rot and mildew
Available in 9m, 12m & 15m lengths Reinforced eyes
Max. stretch & recovery ability Recovery bags and kits available


Handy hints when using your strap

Line up the rescue vehicle as directly as possible in front of the trapped vehicle

Fully uncoil the strap and attach one end to the trapped vehicle's tow hook. Attach the other end to the rescue vehicle's tow hook. Be sure the strap is not going to interfere with any of the vehicle's working parts when tension is applied. Avoid sharp objects that may cut the strap. Never use a strap that is badly damaged - they do wear out and it is not worth the risk of sebsequent damage or injury.

Never tie knots in the strap.

When the area between the two vehicles is safely cleared, take up the slack with the rescue vehicle. Back up approximately 2m and take a running start. The amount of slack required will vary according to the amount of traction available. If the first attempt isd unsuccessful, try again using a rocking motion with the rescue vehicle.

If, after several attempts the vehicle remains trapped, consider pulling from the opposite direction if possible. If the vehicle is severly trapped, a winch may be necessary.

When finished, ensure the strap is dry before rolling it up and storing. The strap can be cleaned using mild soap.

Doubles as an excellent towing strap - but avoid dragging.

Winch Extension Straps

Available in 10, 20 and 30 metre lengths Manufactured to Australian Standard AS 1353
High tenacity continuous-multifilament polyester yarn Tested to British Standard BS 5759
Single ply with reinforced folded eyes Breaking strength 4000kg MAX

Tree Trunk Protector

Tree Trunk Protectors are designed to protect trees from the cutting actions of winch cables. The strap wraps around the trunk and is secured with a bow shackle. To improve the mechanical advantage, a winch pulley can be used.

Length 3 metres Manufactured to Australian Standard AS 1353
High tenacity continuous-multifilament polyester yarn Tested to British Standard BS 5759
Single ply with reinforced folded eyes Breaking strength 8000kg MAX

  This website is © 4WD Systems 1998 - 2007 | disclaimer